Commit 560fac95 authored by Mathias Nyman's avatar Mathias Nyman Committed by Greg Kroah-Hartman

usb: Use the USB_SS_MULT() macro to get the burst multiplier.

commit ff30cbc8da425754e8ab96904db1d295bd034f27 upstream.

Bits 1:0 of the bmAttributes are used for the burst multiplier.
The rest of the bits used to be reserved (zero), but USB3.1 takes bit 7
into use.

Use the existing USB_SS_MULT() macro instead to make sure the mult value
and hence max packet calculations are correct for USB3.1 devices.

Note that burst multiplier in bmAttributes is zero based and that
the USB_SS_MULT() macro adds one.
Signed-off-by: default avatarMathias Nyman <mathias.nyman@linux.intel.com>
Signed-off-by: default avatarGreg Kroah-Hartman <gregkh@linuxfoundation.org>
parent db3611bc
......@@ -114,7 +114,7 @@ static void usb_parse_ss_endpoint_companion(struct device *ddev, int cfgno,
cfgno, inum, asnum, ep->desc.bEndpointAddress);
ep->ss_ep_comp.bmAttributes = 16;
} else if (usb_endpoint_xfer_isoc(&ep->desc) &&
desc->bmAttributes > 2) {
USB_SS_MULT(desc->bmAttributes) > 3) {
dev_warn(ddev, "Isoc endpoint has Mult of %d in "
"config %d interface %d altsetting %d ep %d: "
"setting to 3\n", desc->bmAttributes + 1,
......@@ -123,7 +123,8 @@ static void usb_parse_ss_endpoint_companion(struct device *ddev, int cfgno,
}
if (usb_endpoint_xfer_isoc(&ep->desc))
max_tx = (desc->bMaxBurst + 1) * (desc->bmAttributes + 1) *
max_tx = (desc->bMaxBurst + 1) *
(USB_SS_MULT(desc->bmAttributes)) *
usb_endpoint_maxp(&ep->desc);
else if (usb_endpoint_xfer_int(&ep->desc))
max_tx = usb_endpoint_maxp(&ep->desc) *
......
Markdown is supported
0%
or
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment