Commit 02dadedb authored by Remi Hardy's avatar Remi Hardy

Update TESTING_GNB_W_COTS_UE.md

parent e42cf3db
......@@ -162,6 +162,16 @@ gNB config file :
## Run / Test
The order to run the different components is important:
1- first, CN
2- then, eNB
3- then, gNB
4- finally, switch UE from airplane mode OFF to ON
It is recommended to redirect the run commands to the same log file (fur further analysis and debug), using ```| tee **YOUR_LOG_FILE**``` especially for eNB and gNB.
It is not very useful for the CN.
The test takes typically a few seconds, max 10-15 seconds. If it takes more than 30 seconds, there is a problem.
- **EPC** (on EPC host):
......@@ -172,15 +182,31 @@ https://github.com/OPENAIRINTERFACE/openair-epc-fed/blob/master-documentation/do
- **eNB** (on the eNB host):
Execute:
```
~/openairinterface5g/cmake_targets/ran_build/build$ sudo ./lte-softmodem -O **YOUR_ENB_CONF_FILE** | tee **YOUR_LOG_FILE**
```
for example:
```
~/openairinterface5g/cmake_targets/ran_build/build$ sudo ./lte-softmodem -O ../../../targets/PROJECTS/GENERIC-LTE-EPC/CONF/enb.band7.tm1.50PRB.usrpb210.conf (-E)
~/openairinterface5g/cmake_targets/ran_build/build$ sudo ./lte-softmodem -O ../../../targets/PROJECTS/GENERIC-LTE-EPC/CONF/enb.band7.tm1.50PRB.usrpb210.conf | tee mylogfile.log
```
- **gNB** (on the gNB host)
Execute:
```
~/openairinterface5g/cmake_targets/ran_build/build$ sudo ./nr-softmodem -O **YOUR_GNB_CONF_FILE** | tee **YOUR_LOG_FILE**
```
for example:
```
~/openairinterface5g/cmake_targets/ran_build/build$ sudo ./nr-softmodem -O ../../../targets/PROJECTS/GENERIC-LTE-EPC/CONF/gnb.band78.tm1.106PRB.usrpn300.conf (-E)
~/openairinterface5g/cmake_targets/ran_build/build$ sudo ./nr-softmodem -O ../../../targets/PROJECTS/GENERIC-LTE-EPC/CONF/gnb.band78.tm1.106PRB.usrpn300.conf | tee mylogfile.log
```
......
Markdown is supported
0% or .
You are about to add 0 people to the discussion. Proceed with caution.
Finish editing this message first!
Please register or to comment