build_oai asking for Accelercomm drivers even when we dont have this board attached
When attempting to build any of the scopes we are getting the following from oai_build:
Cambridge ❆ sudo ./build_oai --build-lib nrscope
Enabling build of optional shared library nrscope
OPENAIR_DIR = /home/lime/openairinterface5g
Running "cmake -DENABLE_NRSCOPE=ON ../../.."
cmake: /usr/local/lib/libcurl.so.4: no version information available (required by cmake)
-- Found ccache in /usr/bin/ccache. Using ccache. CMake >= 3.4
-- Check if /opt/asn1c/bin/asn1c supports -gen-APER
-- Check if /opt/asn1c/bin/asn1c supports -no-gen-UPER
-- Check if /opt/asn1c/bin/asn1c supports -no-gen-JER
-- Check if /opt/asn1c/bin/asn1c supports -no-gen-BER
-- Check if /opt/asn1c/bin/asn1c supports -no-gen-OER
-- CMAKE_BUILD_TYPE is RelWithDebInfo
-- CPU architecture is x86_64
-- AVX512 intrinsics are ON
-- AVX2 intrinsics are ON
-- Selected E2AP_VERSION: E2AP_V2
-- Selected KPM Version: KPM_V2_03
CMake Error at CMakeLists.txt:506 (message): could not find poll-mode driver for AccelerComm T2 LDPC Offload (rte_baseband_accl_ldpc.so)
-- Configuring incomplete, errors occurred! See also "/home/lime/openairinterface5g/cmake_targets/ran_build/build/CMakeFiles/CMakeOutput.log". build have failed
How do we disable this in the setup options - we dont have any T2 board installed.