UE not sending RRC connexion request in TDD mode

When running UE in TDD mode, UE synchronize to the cell decode MIB Information but do not start RRC connexion procedure (see log below)

Version of OAI UE : v1B0.4

frequency : each run

configuration : see issue #27

extract from log

lte_parms.c: Setting N_RB_DL to 25, ofdm_symbol_size 512 [PHY][I][initial_sync] [UE0] In synch, rx_offset 63760 samples [PHY][I][initial_sync] [UE0] Sending synch status to higher layers [RRC][I][openair_rrc_ue_init] [FRAME 00000][ UE][MOD 00][RNTI 0] Init... [RRC][I][openair_rrc_on] [FRAME 00000][ UE][MOD 00][RNTI 0] OPENAIR RRC IN.... pcfich_reg : 0,12,25,37 Ngroup_PHICH 1 (phich_config_common.phich_resource 1,phich_config_common.phich_duration normal, NidCell 0,Ncp 0, frame_type 1), smallest pcfich REG 0, n0 46, n1 75 (first PHICH REG 0) phich_reg :0 => 1,17,33 [PHY][I][initial_sync] [UE 0] Frame 812 RRC Measurements => rssi -78.8 dBm (dig 46.2 dB, gain 125), N0 -129 dBm, rsrp -103.6 dBm/RE, rsrq 9.0 dB [PHY][I][initial_sync] [UE 0] Frame 812 MIB Information => TDD, NORMAL, NidCell 0, N_RB_DL 25, PHICH DURATION 0, PHICH RESOURCE 1/6, TX_ANT 1 [PHY][I][initial_sync] [UE 0] Frame 812 Measured Carrier Frequency 1910003071 Hz (offset 0 Hz) [HW][I][UE_thread_synch] Got synch: hw_slot_offset 16 [PHY][I][UE_thread] Resynchronizing RX by 63760 samples (mode = 0) [PHY][I][ue_pbch_procedures] [UE 0] frame 814, subframe 0: Adjusting frame counter (PBCH ant_tx=1, frame_tx=815, phase 3, rx_offset 76798) => new frame 815

--> missing RRC connexion procedure log here

AUTOTEST Metric : UE_DLSCH_BITRATE = 0.00 kbps (frame = 900) AUTOTEST Metric : UE_DLSCH_BITRATE = 0.00 kbps (frame = 900) AUTOTEST Metric : UE_DLSCH_BITRATE = 0.00 kbps (frame = 900) AUTOTEST Metric : UE_DLSCH_BITRATE = 0.00 kbps (frame = 900)